SETTING INSTRUCTIONS FOR SEIKO H556 & H558 MOVEMENT
(by Roland Kamp, September 2003)
Notes on different time zones. This watch has three different time zones:
• Analog time.
• Digital time.
• Second digital time, also called local-time, displayed with "-L" in the right corner
of the display.
These three time (zones) work independently, the alarm and hourly chime always refer to
the digital time.
Set analog time.
• Pull crown to position 3, the secondhand stops.
• Set the hands to the correct time by turning the crown in direction X.
• Push the crown back to position (1) to start the analog part of the watch again.
Set digital time.
Switch alarm and hourly chime on/off.
• Push button B until the alarm time is on the display, AL in the right corner of
display.
• Pull crown to position 2 and after 1 second push it back to position 1 again.
Repeat this
• Action until desired function is set, see table below.
Alarm
Hourly chime
Off
On
Blinking
Off
On
On
Off
Off
On
Stopwatch.
• Push button B until the stopwatch is on the display
• Push button A to start and stop timing.
• Hold button A pressed for a second to reset the stopwatch.
• Stopwatch keeps running when changing to a different mode.
Light.
• Push button A to illuminate the digital display. Does not work in stopwatch mode.
Alarm test.
• Push buttons A and B simultaneously to sound the alarm.
|
Q See Home Security System QC444 426 User Guide
Rancilio Coffeemaker epoca User Guide
RIDGID Cordless Saw R884 User Guide
Rinnai Water Heater R98EASME User Guide
Rockford Fosgate Car Stereo System RFX9000 User Guide
Roland Musical Instrument PCR 30 User Guide
Runco Flat Panel Television PL 43DHD User Guide
Sakar Binoculars VIV CS 735 User Guide
Sanyo Vacuum Cleaner SC 18L User Guide
Scag Power Equipment Lawn Mower SMTZ 61 User Guide