PGW170
PGW170
VHF WIRELESS GUITAR SYSTEM
VHF WIRELESS GUITAR SYSTEM
170
PGW
170
PGW
VOLUME
VOLUME
POWER SIGNAL
AUDIO
POWER SIGNAL
AUDIO
MIN
MAX
MIN
MAX
INSTRUCTION MANUAL
INSTRUCTION MANUAL
GUITAR AMPLIFIER
Refer to the installation diagram below.
GUITAR
Using the supplied audio cable, connect from the AF OUT jack socket to the
GUITAR INPUT socket on your guitar amplifier.Connect the mains power
adaptor from "DC 12V" jack to a suitable mains power socket.
Push the battery cover in the front of the bodypack as per the
sketch map; install the provided 9 volt battery, taking care to fit it
with the correct polarity connected.
Switch on the bodypack transmitter. The red LED will come on for
one second and then go off. This indicates correct operation.
If the red LED stays ON or is dim, this indicates the battery is
low and should be changed. If the red LED does not come on at
all, it indicates the battery is dead, and you should change the
battery.
WIRELESS TRANSMITTER
Adjust the volume control on bodypack until you get sufficient
sound from your speaker.
WIRELESS TRANSMITTER
6.35PLUG
4
3
..............
...............
..............
..............
.................................
...................
......................
|
RCA Network Router 605 User Guide
RCA Universal Remote RCR4283N User Guide
Realistic All in One Printer 20 119 User Guide
RedMax Chainsaw GZ4500 User Guide
RIDGID Planer JP06101 User Guide
Salter Housewares Coffee Grinder 7604 0211 01 User Guide
Salter Housewares Scale Body Fat Computer User Guide
Samsung Laptop NP540U4E K01US User Guide
Samsung Microwave Oven SMH8187 User Guide
Sanyo Air Conditioner 42T72R User Guide